Garment Used:
Independent Trading Co – Black Camo Hoodie
What I Used in this Video:
Hotronix Fusion IQ
Siser Easyweed Glitter HTV
Paper Cutter
Weeding Pen
Cameo 3
T-shirt Folder
Procedures:
Place Glitter HTV onto cutting mat
Load it in to your cameo cutter
In your Silhouette Studios – Select Heat Transfer Vinyl Glitter
Remember to always cut your design in REVERSE for HTV
Send it and let your cutter do its thing
Once done cutting, before unloading, I’d recommend to try and weed somewhere on the sheet to make sure its pulls off smooth and easy
then unload.
Meanwhile if I haven’t turned my heat press on, I’d go and turn it on (Hotronix does take almost 15 minutes to heat up to 310F)
Remove HTV from cutting mat
I use the paper cutter to cut away excess vinyl as scraps but can be used for other projects
Start weeding
Use the paper cutter to cut and trim excess if necessary
Time to start pressing…
Always prepress your garment for 5-10 seconds to get any moisture out for better adhering
Using the embroidery helper for the left chest placement
I’d lift the sweater up to make sure everything is aligned and not crooked
Press for 5-10 seconds
Peel off carrier sheet
Place silicone sheet over the htv and shirt then press for another 10 seconds
ALL DONE!!
Must haves that I use A LOT :
Weeding Pen
Paper Cutter
Rotary Cutter
Craft Scissors
Embroiderer Helper
12″ x 24″ Cutting Mat
Hatpress
Siser Easyweed HTV
Shipping Essentials:
T-Shirt Clear Bags
Sticker Clear Bags
T-Shirt Black Shipping Polybags
Check out my Etsy Store | BLVCK LABEL or contact me directly for custom projects!
Leave a Reply